Batterifilm automatisk krympplastmaskin

 

 

 

1 Introduction to device functions and principles

 

2 Equipment Workflow

 

3 Equipment technical parameters

	98% (only refers to product scrap due to equipment reasons)
	Greater than or equal to 40-45PPM, (since the material is slightly different)
	Greater than or equal to 98% (only caused by equipment failure)
	voltage 380V 50Hz; voltage fluctuations less than ± 10%; equipment power: 8KW;
	Greater than or equal to 0.6Mpa (provided by the customer);
	900kg

4 Huvud komponenter

4.1 Hopper: The employee puts the cleaned battery into the hopper, and the hopper automatically feeds the mechanical chain to drive the battery feed.

4.2 Sleeve mechanism: 1 set, including coil unwinding, guide rod, guide rod, guide servo motor, rotary ring cutter, secondary precise positioning of heat shrinkable tube high bottom; battery by cylinder Drive the V-block to achieve precise positioning of the battery. The heat shrinkable tube is fixed length feeding and automatic loop cutting. A tape link is used when replacing the roll to ensure continuity and ease of operation. The cutter is guided by a guide sleeve to ensure accuracy, and the rotary ring cutting of the blade is driven by a stepping motor.

4.3 The position correction mechanism corrects the position of the battery and the magnet fixture before heat shrinking, so that the magnet attracts the center of the bottom of the battery, ensuring that the bottom edge of the heat shrinkage does not touch the magnet and avoid the bottom curling.

4.5 Heat shrinkable box (heat shrinking furnace): hot air shrinking furnace, hot air circulation distribution in the furnace, uniform hot air temperature, precise control, the battery continuously rotates when the conveyor chain moves around the furnace to ensure the uniformity of heat shrinkage of the heat shrinkable tube, The heat shrinkable tube is heat-shrinked and adheres to the surface of the battery and remains beautiful.

4.6 CCD detection: After the shrinkage, the battery is discharged, the CCD detects the battery above the discharge, and the sleeve is heat-shrinked to detect the roundness and appearance to see if there are creases and knurls.

4.7 Transfer and output chain plate mechanism: It is mainly composed of chain sprocket and step drive. It completes the step feeding of the battery, and the loaded battery enters the functional zone such as casing, rubber pad, heat shrinking and discharging. Magnetic plate adsorption battery on the chain plate

 

5 Equipment general configuration and standards

1. Equipment color: standard color or made according to customer's requirements.

2. Measured from the outer wall of the machine 100mm, equipment noise Less than or equal to 80 db.

3. Supplied with English operation manual and equipment maintenance manual.

4. Randomly deliver the electrical control chart of the machine, the pneumatic control chart, and the specifications of the purchased parts.

7. Provide a list of wearing parts, including name, number of single machines, specifications or drawings, brands and other information.

8, The entire line of equipment can be connected to the MES system (but does not contain MES system)

 

6 Equipment use environment requirements

1. Ambient temperature: determined by Party A's plant environment;

2. Control power supply: three-phase 480V, 60HZ/60HZ, 5KVA voltage fluctuation range: +10%~–10%;

3, compressed air: after drying, filtration and voltage regulation: the outlet pressure is greater than 6.0kg / cm2.

 

 

 

 

 

Populära Taggar: